The network setting steps are as follows: 1. First, make sure that the DHCP service has been enabled on the old router.If it is not already turned on, set it to the ON state. 2. Next, we need to change the LAN address of the new router to ensure that it is within the address range of the old router and does not conflict with other devices.To avoid conflicts, it is recommended to set the address of the new router to not duplicate any other device within the DHCP range provided by the old router. 3. Log in to the new router and set up the wireless network.This includes selecting appropriate wireless channels, setting passwords, security levels and other parameters. 4. Connect the old router LAN port to the new router, and turn on the wireless reception function on the mobile device.After searching the home network signal, enter the correct password to connect. 5. Now, all networked devices can share the Internet. Please note that when setting the network, please refer to the instructions of the corresponding equipment to ensure correct operation.If necessary, please consult relevant manufacturers or seek professional technical support.thank you!
Plug the cable directly into the LAN port of the route!!Directly connect to the routing signal with the laptop wirelessly, and then click Open Ruijie to enter the user name and password directly~No other settings are required~
Enter the AP and click "Broadband Settings" in the network tree first -- the working mode is routing mode, WAN mode is static, and the IP address is filled in the IP address of the network segment of the last connected router, such as the 192.168.1. x mask, as shown in Figure 1.Then click Address Management to set the wireless IP address segment of the local LAN. It cannot be the same as the router you are connected to, as shown in Figure 2.Set wireless connection and password.As shown in Figure 3, add 66498518
After ZTE ZXV10 W815N AP was changed to fat AP, the login account and password were set, but the webpage could not be logged in after the Internet cable was plugged in.How should the gods set up? Thank you