In CAD software, you can use the ML command to create parallel lines and set the spacing to 100.The specific steps are as follows: 1. Enter "ML" in the command line and press Enter.Then enter "S" (for scale) and press Enter again.Then enter "100" and press Enter again.At this point, you can draw parallel lines by drawing a line.After specifying the position of the start point and the end point, the system will automatically draw a parallel line with a spacing of 100 between them. 2. Another method is to draw a line first, and then use the offset (OFFSET) command.In the Offset tab, give an offset distance of 100, and then select the line drawn previously.Finally, specify the offset direction. In this example, select a positive offset to get parallel lines with a spacing of 100. The above is the method of creating parallel lines with spacing of 100 in CAD software.I hope it is helpful to you!
First draw a straight line, then click Copy, snap a point on the straight line, click, enter 100, and then press Enter.Note: When you enter numbers again, your cursor is on the left side of the line. The line with a spacing of 100 you want appears on the left side, and the right side is the same.