Dismantling the display screen of ASUS notebook requires care and patience. The following are general steps:
1. Turn off and disconnect all power supplies of the laptop, including plugs and batteries.
2. Use a slender and flat object (such as plastic sheet or hair dryer) to gently pry up the plastic panel above the keyboard.Some models may need to remove some screws first to unlock the keyboard.
3. Slowly pull the keyboard panel toward you, and make sure not to use too much force to avoid damaging the connection line.
4. Find the flat gray or color cable connecting the display and the host.This line is usually located on the back or bottom, and it may be plugged into the host through a connector.
5. Gently pull out the connector from the socket.If you encounter difficulties, be careful not to damage any parts.
6. Remove any other screws connected to the display screen.Please note the position of each screw so that it can be correctly placed when reinstalling later.
7. Hold the shell edges on both sides of the display screen and gradually lift them until they are completely separated.Please avoid overexertion, and be careful in this process.
8. Make sure the display is completely separated, and then the display can be further cleaned or replaced.
Please note that these steps are only basic guidelines, and the specific operation may vary depending on the laptop model and design.It is strongly recommended to consult the notebook's user manual or seek professional technical support to ensure that the display is properly removed and to avoid damaging the device.
Just like the ordinary monitor, it is bold and careful to arrange the cables, because the operation of the connecting board is to gently shake on both sides and pull outward
The base of the monitor will have screw clips. You can unscrew the screw clips to loosen them and then remove the base. For details, please refer to the user manual of this monitor.
Thank you for your support and attention to ASUS, and wish you a happy life!
It is not recommended to disassemble the machine by yourself, which will affect the warranty.If maintenance is needed, it is recommended to go to the service center for maintenance.
The computer has been hot for a year and a half, so it's time to clean up the dust.Now I have sorted out the solutions for dismantling ASUS notebook monitors, hoping to help everyone~ Method of disassembling ASUS notebook display 1. Screw the screw pry clip.Use a screwdriver to unscrew all the screws of the rear cover, and use a blade or flat screwdriver to pry the surrounding clips. 2. Remove the keyboard and disconnect the cable.This laptop needs to be dismantled in an integrated way. The keyboard will come down directly after the snap is pried off before, but pay attention to the keyboard cable.Lighter, be careful to break the connection.
3. Remove the CD player.The CD player has a screw. Use a screwdriver to unscrew the screw and pull out the CD player. 4. Remove the hard disk.The hard disk has four screws, which are inserted in the motherboard slot. Unscrew the screws, pull the hard disk up and to the right, pay attention to the cable on the hard disk, and pull out the cable on both sides. 5. Unplug the network card cable, pay attention to the order, black and white cable.Unplug the surrounding patch cord. 6. Unplug the screen cable, which should be used to power on the computer. Sometimes you forget to plug in the cable, and the computer does not power on. 7. Remove the main board, unscrew the screws on the main board, and remove the main board. 8. Remove the CPU fan and start cleaning the dust.Carefully unplug the cpu fan cable and remove the fan.Clean the dust with a brush.Look at the picture. There is a lot of dust. 9. Apply silicone grease. The previous silicone grease has been used up and reapplied. matters needing attention 1. Remove and handle with care, and be careful to damage the connecting wire. 2. Remember to use silicone grease, which directly affects heat dissipation.
