This problem is easy to solve. The controller of table controlled TPC8-8TD can be used to control the stepping motor, which is simple and easy to operate.Use the form setting method, and use the mouse to set on the form, without professional skills.The meter control of this model is 8-way input and 8-way output, with 4-way pulse output terminals, and can control up to 4 stepper motors at the same time.Another feature is that it can not only control the stepping motor, but also control the cylinder, AC motor and other loads to work at the same time. The following figure is a picture of the function setting table:
The figure above shows the setting of one action of the stepper motor, which only needs one line to work.It is set in the figure that the input end is started by X1 switch, Y1 outputs 12000 pulses, and the pulse frequency is 5000.12000 pulses are output for automatic stop, which is one of the methods for setting the stepping motor. Working with the set number of pulses, it can realize the operation according to the size or control the operation angle. The following figure shows the physical photos of the surface control TPC8-8TD:
The following figure is the wiring diagram of the meter control stepping motor:
The above figure is the wiring diagram for controlling a single stepper motor. The meter control outputs pulse signal from Y1, and direction signal from Y to the stepper motor driver.There are also 2-axis and 4-axis wiring diagrams, which can be downloaded online if necessary.
A stepper driver with its own programming control program can be programmed by itself with its own programming software and program instructions in the manual.Q series stepper drivers can be equipped with programming control software to directly control the stepper motor, but this cost is a little high.
The serial port stepping motor driver can be directly connected to the computer. The software is provided by the driver, and no other foundation is required. The relatively complex motion process control can be completed by operating according to the instructions
Check MACH3 engraving machine online.Engraving machines are all controlled by computers.The serial port of the computer outputs pulses to the stepper motor driver, and then controls the rotation and speed of the motor.Just download a MACH3 software.Chinese version is required.
1. The stepping motor is driven by pulse current, and there is a ready power supply for driving the stepping motor. 2. The computer cannot directly drive the stepping motor drive power supply, but there are many ready-made stepping motor drive cards that can be inserted into the computer to control the stepping motor to work automatically. 3. If you buy a stepping motor drive card, the business will provide many routines, and you can write them according to the routines.
ZOL Q&A>notebook>Other classifications>It can control the stepping motor to work automatically without using PLC and MCU.It is most convenient to use computer to control or control
