Hello! Epson L1300 adopts a clamshell three section folding structure;Expand the fuselage after expansion, and then directly transfer the A3+paper.Put it in the paper tray
Imagine this operation: after opening the top cover of the printer, there is a specially designed large size media slot on the left.Place A3 in parallel from the long side and ensure that its front end is aligned with the sensor area.Slowly push in until you hear a click, and then the locking is completed. Remember to check whether there is an angle or dislocation
To correctly place A3 in L1300, please keep calm and not impatient.After opening the case, find an entrance called large document mode (usually indicated by an arrow), put your A3 into the notch along this direction, and press the small buttons on both sides with your fingers to lock it in place
I can't send the picture directly to you, but imagine: first pull out the side handle and lift it into the paper box, place A3 horizontally, and stop at the place where there are fixed bars on both sides.Then lower the handle and fine tune the height of the deflector to fit the large page.Finally confirm that there is no skew or overlap, and then close the paper feed box
To place A3 paper in Epson L1300, first open the front cover of the printer, place the paper sheet flat on the left edge of the paper feed box, and ensure that the paper width exceeds the border.Adjust the guide so that the paper head is aligned with the top edge, and then gently push it in until it clicks.Remember to close the front cover gently to avoid wrinkling large paper