My notebook Hewlett Packard HP431 Notebook PC has 2GB of memory (Samsung DOR31333MHZ) and 1GB of memory. I want to add a suitable memory moduleYou'd better send me all the addresses of the memory module JD. How much is itView All
HP laptop plus memory is like icing on the DIY cake: after determining compatibility, it is safer to operate in safe mode.Turn off the computer, remove the battery and power cord, and open the memory hatch.If it is SO-DIMM type, it will be replaced directly;If it is a SODIMM, it is necessary to carefully remove the old strip along the plastic buckle and then install the new strip, and ensure that the contact is good without loosening.Finally, don't forget to save the data and restart the test
Want to add memory?It's simple!Check the manual first to confirm how large capacity and frequency modules you need.After shutdown, open the side or bottom door, which usually has two or four slots.Take out the old RAM, if any (it may not be installed), push the new strip into the groove and lock it.Remember to power on and check whether the system recognizes successfully
First confirm that your HP notebook supports extended memory, and then purchase RAM of the same type and speed (such as SO-DIMM).After powering off the computer, find the location of the memory module (usually the small cover plate on both sides), open and hold the old memory stick, pull it out on both sides, and then insert a new one.Remember to pay attention to the positive and negative directions during installation
Adding a memory module to your HP laptop is like upgrading a car's fuel tank. First, make sure that you buy a memory specification that is compatible with the original computer (such as DDR4 or DDR3). Turn on the laptop after you turn it off. Usually, there is a cover at the bottom or side that can be opened to see the memory socket.The new memory module should be inserted into the notch and pressed down gently until it is clamped.Restart the computer after completion to check whether the new memory is recognized
